Tag: Reconditioning
1986 Corvette Fuel Leak Fixed
The video shows the results of repaired vacuum lines, which were the cause of fuel leaking into the plenum on my car.
Posted: December 3rd, 2011 under videos.
Tags: auto, automotive, C4, canister, cars, CARWIZ, Chevrolet Corvette (C6), chevrolet-corvette, eecs, engine, mr, Reconditioning, repair, Restoration, start, vacuum, valve
Comments: none
Replace ignition coil on 1986 Chevrolet Corvette
This video shows more work done to my 1986 Corvette project. Also how to replace the ignition coil on top of an 8 cylinder HEI distrubtor cap.
Posted: October 27th, 2011 under videos.
Tags: automotive, cars, chevrolet, corvette, diy, electronics, engine, gas, howto, malibu, Reconditioning, repair, Restoration, spirituality, start, used
Comments: 1
1986 Corvette E-test Results
After rebuilding the entire fuel delivery system, replacing the valve cover gaskets, adjusting the TPS and idle set screw, fixing a cut tube on the exhaust system, and power washing the engine, my project failed the emissions test again. Now it’s going back to my brothers shop to make it pass emissions. The car runs [...]
Posted: October 15th, 2011 under videos.
Tags: 'vette, automotive, C4, chevrolet, contest, corvette, drag, extreme driving, race, Rebuilding, Reconditioning, refurbishing, Restoration
Comments: none
1986 Corvette Fine Tuning Emissions, Vacuum Hoses, and Plug Wires
This video shows the vacuum hose routing, solenoid, diverter, and check valves in the Emissions system on a 1986 Chevrolet Corvette, and how to service the components.
Posted: September 29th, 2011 under videos.
Tags: 'vette, auto, automotive, Burnout, chevrolet, corvette, drag, drifting, emissions, engine, exhaust, gas, high, Mustang, performance, plugs, race, racing, Reconditioning, repair, Restoration, spark, thomas, turbo
Comments: none
1986 Corvette Fine Tuning Emissions, Vacuum Hoses, and Plug …
This video shows the vacuum hose routing, solenoid, diverter, and check valves in the Emissions system on a 1986 Chevrolet Corvette , and how to service the.
Posted: September 27th, 2011 under Blog posts, Uncategorized, videos.
Tags: chevrolet, exhaust, performance, racing, Reconditioning, repair, spark, Uncategorized
Comments: none
Replace ignition coil on 1986 Chevrolet Corvette
This video shows more work done to my 1986 Corvette project. Also how to replace the ignition coil on top of an 8 cylinder HEI distrubtor cap.
Posted: July 14th, 2011 under Blog posts, videos.
Tags: automotive, cars, chevrolet, corvette, electronics, engine, howto, Reconditioning, Restoration, spirituality, videos
Comments: none
1986 Corvette Wheel Bearings Replaced – Test Drive
This video shows the starting of the vette after removing the fuel pump and cleaning the strainer, and test driving after replacing the rear wheel hub assemblies. I still have a little more work to do.
Posted: April 30th, 2011 under videos.
Tags: 'vette, 1986, airplane, automobiles, C4, cars, chevrolet, chevy, chips, corvette, Coupe, custom, diy, driving, electronics, engine, extreme driving, HIGH SPEED, howto, injection, installation, instruction, mod, motor sports, offroad, port, racing, rail, Reconditioning, repair, Restoration, semiconductors, technology, TPI, Tuned, valve, vehicle, wireless
Comments: none
1986 Corvette Rear Hub Replacement Part 2
This video shows the completed job of replacing the left and right rear hub assemblies on my 1986 Chevrolet Corvette project.
Posted: April 27th, 2011 under videos.
Tags: 1986, auto, C4, christianity, corvette, crafts, extreme driving, howto, motor sports, racing, Reconditioning, repair, Restoration
Comments: none